Verschillen voor "CUPRO Planning"

Verschillen tussen versies 1 en 3 (omvat 2 versies)
⇤ ← Versie 1 sinds 2016-10-12 12:13:58 →
Grootte: 2018
Auteur: WiebeVanDerWorp
Commentaar:
← Versie 3 sinds 2017-03-11 14:09:24 → ⇥
Grootte: 0
Auteur: WiebeVanDerWorp
Commentaar:
Verwijderingen worden op deze manier gemarkeerd. Toevoegingen worden op deze manier gemarkeerd.
Regel 1: Regel 1:
CUPRO needs some serious attention and updating:
 * Abbreviations are not logical because they are based on Dutch.
  * Current main classes are:
   * Cold rolled shapes (constant material thickness, bending radius)
   * Extruded shapes (typical sharp corners)
   * Hot rolled shapes (industry standard shapes, currently DIN)
  * In addition to C, E and H there is a need for Free form (F) shapes.
  * This creates a challenge: All options directly available or first choose a main class.
   * A best of both approach is possible: Choose main class and enter an option or enter a valid option directly.
   * It is very tempting to create a DCL dialogue for all options but this slows down power users. A dialogue may be considered as a main option but it requires a lot of work
 * There are several technical improvements possible.
  * 2D and 3D:
   * For 2D or 3D: Press enter (2D) or extrusion height (3D)
    * For 2D the result is now a region. If exploded coherence is lost. The result should be a polyline (or circles in case of round tube) or a set of polylines in case of hollow chambers. In that case these entities can be grouped be means of an unnamed group.
    * For 3D the result is a solid. It is not logical to create surfaces so this does not need to be changed.
  * The current UCS defines placement. A temporary UCS - based on entered insertion point and entered angle - is an interesting way to work with. If the sizes are known, some handy move and rotate shortcuts can be made: L = move half width left, R = right, U = up, D = down. P for rotate Plus 90 degrees, M for minus 90 degrees. Finally V = Flip vertical and H = Horizontal. UCS should be restored.
 * Content
  * Catalogues (.cat files) can be extended with other than DIN profiles. All over the world different structural steel profiles are used. See https://en.wikipedia.org/wiki/Structural_steel#Standards.
  * Several Free form profiles can be added like rubber hollow chamber, elliptical tube and half round rods.

This site is hosted by StringIT.

Information and software on this site is offered -as is- without any warranty and licensed in different ways. You should read the page about licensing before use.